Samsung Error Codes

Unbalanced load — the drum cannot spin safely due to unevenly distributed laundry.

No Drain — water is not draining from the drum within the expected time.

Water supply error — the machine is not receiving enough water or no water at all.

Drain error — similar to ND but specifically a pump communication or sensor fault.

Door Check — door is not properly closed or latch is not engaging.

Spin Error — the drum is unable to reach the target spin speed.

Leak Error — the leak sensor at the bottom of the machine has detected water.

Water Level Pressure Sensor Error — the sensor that monitors water level has malfunctioned.

Temperature Sensor Error — the thermistor monitoring water temperature has failed.

Motor Error — the drum motor is not running or has stopped unexpectedly.

Excessive Suds Detected — too many suds are preventing the drum from draining and spinning safely.

Unbalanced Load During Spin — similar to UE; drum cannot balance laundry to reach spin speed.

Button Error — a button on the control panel is stuck or being continuously registered.

Water Supply Error — machine is not receiving water or water pressure is too low.

Heating Error — dryer is overheating or the heating element is malfunctioning.

Frequency Error — power supply frequency mismatch (common in areas with unstable power).

Exhaust Thermistor Error — the temperature sensor in the exhaust duct has failed or reads out of range.

Door Error — the dryer door is open or the door switch is not detecting closure.

Heat control error — the dryer is overheating due to restricted airflow or faulty components.

Frequency error — the power supply frequency is inconsistent.

Door open error — the dryer door is not properly closed or the door latch is faulty.

Error in the exhaust temperature sensor — the sensor is reading incorrectly.

Temperature Sensor Short — the inlet thermistor is reading a short circuit.

Temperature Sensor Open — the inlet thermistor is reading an open circuit (disconnected or failed).

Communication Error — the main control board and the sub-board are not communicating.

High Temperature Error — water in the dishwasher has reached an unsafe temperature.

Overflow Error — too much water has entered the machine.

Leakage Error — water has been detected in the base pan of the dishwasher.

Water Supply Error — the dishwasher is not receiving sufficient water.

Water Wall Reflector Error — the WaterWall reflector motor or sensor has faulted (WaterWall models only).

Button Error — a control panel button is stuck or continuously pressed.

Control Board Communication Error — the display or main board is not communicating correctly.

Pantry Communication Error — the pantry or flex zone module is not communicating with the main board.

Demo Mode / Cooling Off — the refrigerator is in showroom demo mode and is not cooling.

Power failure or temperature display reset — the display is showing default error after power interruption.

Freezer sensor error — the temperature sensor in the freezer is malfunctioning.

Pantry sensor error — the temperature sensor for the flex zone or pantry drawer is malfunctioning.

Freezer Sensor Error — the freezer compartment temperature sensor has failed.

Refrigerator Temperature Sensor Error — the main fridge compartment sensor has faulted.

Ice Maker Sensor Error — the temperature sensor on the ice maker has failed.

Freezer Sensor Error — the temperature sensor in the freezer section is malfunctioning.

Defrost Sensor Error — the defrost system temperature sensor has failed.